Cytron 13Amp 6V-30V DC Motor Driver

350.00 EGP

MD13S is an easy to use DC brush motor driver. It can drive one DC brushed motor bidirectionally from 6V30V up to 30Amp peak current.

Out of stock

Overview

A brushed motor is the most widely used motor because of the ease of operation. Just supply the two terminals DC power supply, the motor will start rotating! Yet, you need a good motor driver to control the speed and direction from the microcontroller. You are at the right page, MD13S is one of the easiest to use the brushed motor driver.

MD13S has great improvement in current protection which MD10C does not have. With the new circuit and design, MD13S is able to limit and support current up to 30A max(10 seconds). And the continuous current is at 13A without a heatsink (at room temperature of 25°C).

Not to forget it is GROVE compatible, so get yourself a Grove shield. Oh, did I mention? MD13S is smaller than MD10C 🙂

Which brush motor is good to be driven by MD13S? As long as the motor:

  • Is DC Brush motor (Two Terminals)
  • Operating voltage from 6V to 30V
  • Rated Current ≤ 13A
  • Peak Current ≤ 30A

Example of suitable DC brush motor with MD13S (Not limit to):

Features:

  • Bi-directional control for 1 brushed DC motor
  • Support motor voltage from  6V to 30VDC
  • Maximum current up to 13A continuous and 30A peak (10 seconds)
  • GROVE compatible
  • 3.3V and 5V logic level input.
  • Solid state components provide faster response time and eliminate the wear and tear of mechanical relay
  • Fully NMOS H-Bridge for better efficiency and no heat sink is required
  • Regenerative Braking
  • Speed control PWM frequency up to 20KHz (Actual output frequency is same as input frequency)
  • Support both locked-antiphase and sign-magnitude PWM operation, *NOT RC (Radio Control) PWM
  • SMD compatible
  • RoHS, FCC and CE compliance
  • Dimension: 61mm x 33mm

Documents/Example Code: 

Packing List:

  • 1 x MD13S motor driver board
  • 1 x Green + Black 2-way terminal blocks (Normally Black is for MotorGreen is for Power)
  • 1 x Grove connector (Grove to Grove)

Check out some of the videos by user:

Specifications

Operating Condition
Compatible input 3.3 and 5V
Motor Channel 1
Operating Voltage (VDC) 6 to 30
Peak Current (A) 30 (10 seconds)
Continuous Current (A) 13
Operating Modes
Arduino Shield No- can be used with Wire connection
PWM (Lock-Antiphase and Sign-Magnitude) Yes
UART No
Analog No
RC Servo Signal No
Special Protection
Polarity Protection NO
Appearance
LEDs Indicator Yes
Test/Manual Button Yes
Cooling Fan No
Other Features
Extra Socket Groove Compatible
others No heat sink is required

Need Help?

Please get in touch with us through our Contact Us page.

 

Reviews

There are no reviews yet.

Be the first to review “Cytron 13Amp 6V-30V DC Motor Driver”

Category: Tags: , ,